The status of these LEDs is exactly the same as the LEDs on the rear of nearly any other Ethernet port, and are more likely to indicate problems with your network than with the configuration of the Raspberry Pi itself. This happens as the networking stack is initiated and forms a link with your Ethernet network. Very soon after Linux starts to boot, there will also be a flicker of the fourth LED (LNK), followed by the remainder of the networking LEDs lighting up about half a second later – these LEDs on newer models are found built into the network Ethernet port. If your Raspberry Pi has been able to successfully negotiate the early boot procedure, the operating system will start being read off the card in earnest. Booting NOOBS works a bit differently, as it will always output a HDMI signal, (even if you have nothing connected to the HDMI port) unless you press one of the numerical keys 3 (PAL) or 4 (NTSC) to switch to a composite video output mode. It may even mean that the monitor must be switched to HDMI input. That sometimes means you have to turn on your monitor before booting. The Raspberry PI (and its Raspbian OS) is designed to output a HDMI signal, but if it doesn't detect a HDMI device connected it will default to generating a composite signal on the RCA port (or 4-pins 3.5mm A/V jack on model B+). If it makes it past this and no further, then the problem is once again in the hands of your power supply.Įven when booting sometimes you won't immediately get a video signal. If you've got your Raspberry Pi connected to a display, recent versions will also show a kaleidoscopic boot screen. These are available cheaply, but they can often be found bundled with the SD cards themselves. However, we have experienced problems with several SD card readers – especially those embedded within laptops and netbooks – and we'd suggest switching to a standalone reader first to see if that helps. Our Raspberry Pi installation guides for Windows, Linux and Mac OSX covers three different operating systems, so it might be worth trying a friend who uses something else. Take a look at something called a checksum and make sure the checksum for the files on the card is the same as the checksums for the original files.Īs these read errors are more likely to be an indication of either the SD card not being read correctly, or the Raspberry Pi operating system not being written correctly, we'd recommend trying to get hold of a new card first and writing the image with a different method. It is possible to troubleshoot these problems by looking for the files involved and making sure they're correct.

You need newer bootcode.bin/start.elf firmware, or your SDRAM is damaged.įor devices made before October 2012 or old devices there have never been updated:

Lakka raspberry pi 3 no ip